Breakout Interface Board ΙI for Servo or Stepper Motors
Product code: 12-0211
Weight: 0.144 Kg
Measurement: τμχ
VAT is not included (24%)
In stock (15-30 days)
Show shipping cost estimation
Weight: 0.144 Kg
Measurement: τμχ
€ 104,88
VAT is not included (24%)

Show shipping cost estimation
Description
- Provides the 12-wires OC output(Open collector NPN),P2-P7 6-wires high speed optical isolated coupling, the output port can drive the solid state relay directly
- 12-wires optical isolated common signal input
- All the input and output have the signal alarm
- Single power supply 12VDC
- All the input signals of the PC parallel port are modified by the Schmitt Trigger and increase the anti-jamming capacity of the transmission of the digital signal
- Using Mach 2, 3 as the controlling software, makes the application of the PC as the industrial control possible
- As the lack of the IO of the PC parallel port, we add 3 axis 6bit independent Limit switch of the IO input
- Compatible with all the pulse and direction signal of the Stepper or Servo driver , can control the lathe and milling machine to work
- The input part can connect to the mechanical switch , groove optocoupler, proximity switch , tool presetter etc.
- The interface board P1-P17 port correspond to the pin1-17 of the PC parallel port , the parallel port pin 18-25 is the GND.
- Controls the 2-wires electromagnetic relay output by the parallel P1 and P16 , this can control the cooling pump and lubricating oil pump of the lathe
- The setup of the P17 in the Mach 3 for the charge pump can control the solid state relay output to increase the safety of the lathe
- The P14 can provide the accurate 0-10V analog voltage for the main axis speed control signal , this can make the frenquency of the speed of the spindle
Dimension
140mm*100mm
Locating hole
122mm*82mm