4 Axis USB CNC Interface for Stepper Motor Driver
Product code: 12-0262
Weight: 0.41 Kg
Measurement: τμχ
VAT is not included (24%)
Readily available - (Quantity: 2)
Show shipping cost estimation
Weight: 0.41 Kg
Measurement: τμχ
€ 99,00
VAT is not included (24%)

Show shipping cost estimation
Description
USBCNCV4.0 is a high performance motion controller which is based on PC software USBCNC control. The system can complete the conversion from G code to connect with the stepper motorΆs driver motion control signal without requiring any additional hardware and software. This control card is compatible with the most stepper drivers and servo drivers, it is a perfect controller that can be used instead of parallel Mach3 interface board.
Detailed functional introduction:
Card input voltage: 15~36v
Limit port working voltage: 12V
Stepper motor control signal output voltage: 5V
External power supply voltage: 12V
Card input voltage: 15~36v
Limit port working voltage: 12V
Stepper motor control signal output voltage: 5V
External power supply voltage: 12V
Minimum Computer System Requirements:
CPU:1GHz
Memory: 512MB
500MB free disk space
DIRECTX9 graphics device with WDDM 1.0 or higher driver
USB 2.0 interface
Net FRAMEWORK 3.5SP1
WinXP,not Win7
CPU:1GHz
Memory: 512MB
500MB free disk space
DIRECTX9 graphics device with WDDM 1.0 or higher driver
USB 2.0 interface
Net FRAMEWORK 3.5SP1
WinXP,not Win7
NOTE:
This driver board is controlled by USB port and can only be used with the CNC software especially designed for this board. It cannot be used with MACH3, KCAM4 or other CNC softwares.
Users should follow its manual and install the software correctly.
This driver board is controlled by USB port and can only be used with the CNC software especially designed for this board. It cannot be used with MACH3, KCAM4 or other CNC softwares.
Users should follow its manual and install the software correctly.
Other products
202,44 € | 99,00 € | 99,00 € | 155,40 € |