Electromagnetic marking needle head

Κωδικός προϊόντος: 10-0294

Βάρος: 0.800 Kg


€ 240,00


Στο παρόν προϊόν δεν ισχύει η αντικαταβολή.


Οι τιμές δεν περιλαμβάνουν ΦΠΑ (24%)


        Αμεσα Διαθέσιμο - (Ποσότητα: 1)
Show shipping cost estimation
Περιγραφή
 
Controller size
90mm 37mm x 21mm (LxWxH)
Controller mounting hole spacing size
73mm Φ3x2
Marking needle Assembly
Lenght: 71mm
Φ36mm(Maximum diameter)
Needle core diameter
2.5mm 3.5mm
Strength frequency conversion
Yes
Needle core replacement
Yes
Minimum needle distance
0.5mm
Maximum needle distance
4mm
Applicable material
Hard plastic, Aluminum, Iron, Stainless steel, etc.
Needle core hardness
HRA94
Highest marking hardness
HRC68
Printable
lines or dot matrix
 
Input voltage
DC24V 5%
Power
6-20W
Depending on the marking strength)
Input signal
24V 10% High level effective
Marking assembly maximum operating temperature
45
 
Misoperation protection with adjustment button
Internal automatic control circuit with precision
Energy saving design, Low energy consumption processing in non-working state, Power consumption is less than 0.3W
Waterproof, dustproof, oil prevention, shockproof.
 
Electrical connection
Red Line: +24V Input (Directly connected to the switch power supply+24V)
Black line: GND (Directly connected to the switch power supplyGNDOr0V)
White line: Adjustment of strength (Need to connect the self-reset switch)
Blue Line: Signal input (The positive pole of the solenoid valve terminal on the control board)
Yellow Line: Electromagnetic marking Assembly (Infinite distinction)
 
Unit:mm