Automatic Pneumatic Positioning Cylinder 30mm Stroke, 25mm Shaft Lenght

Κωδικός προϊόντος: 13-0993

Βάρος: 0.557 Kg

€ 81,07

Οι τιμές δεν περιλαμβάνουν ΦΠΑ (24%)

Διαθεσιμότητα (15-30 days)
Show shipping cost estimation

Περιγραφή

Working medium
Dry clean air containing oil mist after dewatering filter cake

Medium and ambient humidity
5-60 degrees Celsius (compressed air below 50 degrees Celsius needs special water removal treatment)

Relative humidity
<85%.

Common working pressure range
0.4-0.63MPa.

Reference speed
250mm/s (mm/s).

Advantages of positioning cylinders

Pure aluminum alloy cylinder
New aluminum alloy material, surface plating Processing, high strength, no deformation, long Time is not easy to resist corrosion
Two-way sealing ring
Two-way seals, wear-resistant and high-temperature resistant, effectively prevent air leakage, and can work for a long time .
Thickened copper sleeve
Thicker copper sleeve, high precision, small shaking time, better sealing
Comes with stand
The cylinder body and the bracket are integrally formed to effectively prevent the cylinder body from shifting and shaking during work, and also save About the cost.
The cylinder should be placed in a ventilated and dry warehouse to prevent moisture and rust.
The cylinder should be tested under no-load conditions before installation. After that it can be installed normaly.
Choose the installation form according to the conditions of use, and pay attention to:

> Earring installation, middle shaft pin installation, the force of Qi should be in the same plane.

> Flange installation, the effective force is on the same axis as the support center. The connection between the flange and the support base should make the flange surface bear the force, and not the fixing screw to bear the relay force.

> The cylinder piston rod is not allowed to bear eccentric load or lateral load. Super long stroke cylinder should be equipped with support or guide.
Before the cylinder is connected to the pipeline Remove the dirt in the pipeline to prevent debris and dust from entering the cylinder cavity.
If necessary, the cushion valve core can be adjusted to adjust the effect of cushioning to avoid collision between the piston and the cylinder head and damage the parts. The fasteners should be checked frequently during use to prevent loosening.
The passage of the cylinder inlet and exhaust pipe joints should generally be adapted to the cylinder diameter.

The user installs a one-way throttle valve in the inlet and exhaust pipes according to the usage to adjust the movement speed of the cylinder piston rod.